Recommended latency: 1500-2500ms
Setting the latency too low will increase glitching and reduce the bitrate that can be sustained
1. Point your BELABOX at this server
Connect to your encoder over SSH (the username and password are shown in belaUI under System) and run:
This installs an agent that redirects belaUI to this server. It does
not modify belaUI itself, so BELABOX updates will not undo it. To
undo it yourself, run sudo bb-agent uninstall.
2. Choose a remote key
Open belaUI on your encoder (usually belabox.local), scroll to Remote, and enter a key of your choosing. Any key works — it is what links this page to your encoder. Treat it like a password: anyone who has it can control your encoder and see its stream settings.
3. Enter the same key above
Your encoder should appear within a few seconds. Bookmark the resulting page — it contains your key, so keep it private.
Software update in progress
The encoder will briefly disconnect after a successful update
Never remove power or reset the encoder while updating
Preparing update...
Downloading:
Unpacking:
Setting up:
Recommended latency: 1500-2500ms
Setting the latency too low will increase glitching and reduce the bitrate that can be sustained